Leak-Free Skylight Installation and Repair in San Antonio

Here's what most people miss about skylights. The glass itself rarely fails. Leaks start at the flashing, where the skylight meets your roof. Because we're roofers first, we tie that flashing into your shingles and underlayment the same way we'd seal any roof penetration. That's the difference between a skylight that lasts and one that drips two rainy seasons later.

For our climate, the glass you pick matters as much as the install. We point most homeowners toward low-E, impact-rated skylights that cut the harsh summer heat gain and hold up to area hailstorms. If your roof is older, it's often smarter to add or swap a skylight during a roof repair or roof replacement, so the flashing and shingles go down together. Not sure what shape your roof is in? A free roof inspection sorts that out fast.

Do skylights leak?

A properly installed skylight should not leak. Most leaks trace back to bad flashing, not the skylight itself. We tie the flashing into your shingles and underlayment so water sheds around the unit, the same method we use for any roof penetration. That's where a roofer beats a handyman install.

What kind of skylight holds up best in Texas heat?

Low-E glass makes the biggest difference. The coating reflects a good chunk of the summer heat and UV while still letting daylight in. We also suggest impact-rated glass, since it handles hail far better than standard panes and can sometimes earn an insurance discount.

Can you repair or replace an existing skylight?

Yes. We re-flash leaking skylights, swap out cracked or fogged glass, and replace older units that have reached the end of their life. If a leak has been going a while, we check the decking and insulation underneath during a 27-point roof inspection so nothing rotten gets sealed back up.

Should I add a skylight during a roof replacement?

If your roof is near the end of its life, yes. Setting the skylight while the shingles are off means the flashing and the new roof go down as one system, which is the most leak-resistant way to do it. It usually costs less than booking the two jobs separately, too.